Call Now 800-537-2514

How it Works:

  • Apply the Impression Cylinder protection plate by exposing the adhesive on the back. Position the plate on the Impression sheet in the proper position.
  • Remove the blanket and packing from the blanket cylinder.
  • Insert the IOC flexible die, with bar, into the cylinder leading bar clamp and tighten evenly.
  • Insert the IOC base set under die.
  • Inch the press forward until the rear clamping bar is accessible then insert IOC trailing edge bar into accessible bar clamp.
  • Tighten the bar until the IOC die is snug around the cylinder
  • The IOC die system is now installed.
  • When feeding first sheet through press adjust cutting pressure until optimum cutting result is achieved.